Today, 08:23 AM
Hello everyone! I’m planning to build an electronic focuser using a NEMA 17 stepper motor (sourced from https://www.skysmotor.co.uk), but I have a few questions regarding the selection process:
1. What holding torque is typically required for a focuser? Is around 40 N·cm sufficient, or would a higher torque be recommended?
2. Is it necessary to use a NEMA 17 motor with a gearbox, or can the required precision be achieved through microstepping?
3. Is there a noticeable difference in actual focusing precision between a 1.8° step angle and a 0.9° step angle?
4. How can I minimize the impact of vibration and resonance on imaging when the motor is running at low speeds?
5. Given the conditions of astrophotography (low temperatures, long operating hours), are there any specific recommendations regarding motor current and heat dissipation?
I would love to hear from those with hands-on experience—any recommendations for specific motor models or lessons learned from past mistakes would be greatly appreciated!
1. What holding torque is typically required for a focuser? Is around 40 N·cm sufficient, or would a higher torque be recommended?
2. Is it necessary to use a NEMA 17 motor with a gearbox, or can the required precision be achieved through microstepping?
3. Is there a noticeable difference in actual focusing precision between a 1.8° step angle and a 0.9° step angle?
4. How can I minimize the impact of vibration and resonance on imaging when the motor is running at low speeds?
5. Given the conditions of astrophotography (low temperatures, long operating hours), are there any specific recommendations regarding motor current and heat dissipation?
I would love to hear from those with hands-on experience—any recommendations for specific motor models or lessons learned from past mistakes would be greatly appreciated!

